CHIEF NG1D28-36-44 - Manual (Page 4)

NE1D20-28-36-44/NG1D28-36-44 Installation Instructions
4
INSTALLATION
IMPORTANT ! : If the door is to be attached with the pull-
ring handle on the right side, the nut and grounding wire
already installed on the door must be removed and
reinstalled on the opposite end of the door before the
door is installed. The grounding wire should be on the
BOTTOM of the installed door. (See Figure 1)
Figure 1
1. Pull down on upper spring handle, and push up on lower
spring handle. (See Figure 2)
Figure 2
2. Insert door into rack, aligning the spring handle ends with
the holes at top and bottom of rack. (See Figure 3)
Figure 3
3. Push spring handle end into rack, and re-latch spring
handle.
Move to
grounding
screw
Move nut and
grounding wire
NOTE: Door will
be flipped before
installation.
(view from back of door)
1
Lower
spring
handle
Upper
spring
handle
(View from back of door)
6
Door
support
Door
Spring
handle end
2
2