CEMB USA TM1 - Manual (Page 4)

A
STA21220
V velocity transducer
A acceleration transducer
A: Type of transducer
ORDER INFORMATION
0 displacement
1 velocity
2 acceleration
B: Dimension measured
All the data and features mentioned in this catalogue are purely for information and
do not constitute any commitment on the part of our company, which reserves the
right to make any and all alterations it may consider suitable without notice.
CEMB S.p.A.
Via Risorgimento, 9
23826 MANDELLO DEL LARIO (LC) Italy
www.cemb.com
e-mail: [email protected]
Vibration analysis division:
phone +39 0341 706111
fax +39 0341 735678
e-mail: [email protected]
B A L A N C I N G M A C H I N E S
/ A / B / C / D / E / F / G / H
The TM1 equipment is supplied according to the conÞ guration selected by the
Customer. However the setting of the operating parameters can be varied
during installation of the system by using the buttons on the control panel or
via serial link RS485 using a PC provided with the appropriate program.
0 RMS
1 peak
2 peak-to-peak
C:Mode of measurement
D: Range of measurement
0 0: 100 µ m
1 0: 200
µ
m
2 0: 250 µ m
3 0: 10 mm/sec
4 0: 20 mm/sec
5 0: 50 mm/sec
6 0: 1 g
7 0: 5 g
8 0: 10 g
9 0: 20 g
S special to be deÞ ned
G: Output signal
0 4: 20 mA
1 0: 20 mA
2 0: 10 V
S special to be deÞ ned
TM1 / / / / / / /
A: transducer, velocity
B: dimension, velocity
C: mode of measurement RMS
D: measuring range 10 mm/sec
E: high bandpass Þ lter 20 Hz
F: low bandpass Þ lter 1000 Hz
G: output 4 : 20 mA
Order example:
/
0 24 Vdc
1 110/220 VAC 50÷60 Hz
H: Power supply
H: power supply 24Vdc TM1
/ A / B / C / D / E / F / G / H
/ V / 1 / 0 / 3 / 2 / 2 / 0 / 0
F: Low bandpass Þ lter
N.B: The low pass Þ lter frequency
should be at least double that of the
high bandpass Þ lter
0 without Þ lter
1 100 Hz
2 1000 Hz
3 2500 Hz
4 5000 Hz
5 10000 Hz
S special to be deÞ ned
E: High bandpass Þ lter
0 without Þ lter
1 5 Hz
2 10 Hz
3 20 Hz
4 50 Hz
5 100 Hz
S special to be deÞ ned