Light kit (continued) – Hunter 59048 52 Palermo User Manual

Page 14

Text mode
Original mode

www.HunterFan.com

1.888.830.1326

M3534-01 • 05/14/14 • © Hunter Fan Company

Light Kit (continued)

Make sure the light kit is securely attached to the mounting
plate. Failure to properly secure all three assembly screws
could result in the light fixture falling.

Thread the 2-pin connector through the wire

slot in the the switch housing.

Wire Slot

Install the remaining attachment screw

to secure the light kit to the mounting

plate. Securely tighten all three screws.

Attachment Screw

Connect the upper 9-pin plug connector

from the fan to the lower 9-pin plug

connector in the light kit.