Hunter 53015 52 Henley - Manual (Page 13)

M0054-01 • 04/14/14 • © Hunter Fan Company
www.HunterFan.com
1.888.830.1326
13
Troubleshooting
Excessive wobbling
• Make sure that the blades
are properly installed on the
blade iron posts.
• Turn the power off, support
the fan carefully, and check
that the hanger ball is
properly seated.
• Use the provided balancing
kit and instructions to balance
the fan.
Noisy Operation
• Make sure that the blades are
properly installed on the blade
iron posts.
• Check to see if any of the blades
are cracked. If so, replace all of
the blades.
Fan doesn’t work
• Make sure power switch is on.
• Pull the pull chain to make sure
it is on.
• Push the motor reversing switch
firmly left or right to ensure that
it is engaged.
• Check the circuit breaker to
ensure the power is turned on.
• Make sure the blades spin freely.
• Turn off power from the circuit
breaker, then loosen the canopy
and check all the connections
according to the wiring diagram
on page 9.
• Check the plug connection in
the switch housing.
M0054-01 • 04/14/14 • © Hunter Fan Company