Turn p ow er, Remote control – Hunter 52096 52 Bellwood User Manual

Page 16

www.HunterFan.com

1.888.830.1326

Remote Control

Note: The remote must be paired before

the fan will operate.

Within 3 minutes of restoring power to

the fan, press both the Fan OFF button and

the Fan ON button for at least 4 seconds.

Your fan will turn on to indicate successful

syncing. If it does not, turn off power to

your fan, wait 1 minute then try again. If

using the transmitter with multiple fans,

repeat this process for each fan.

Fan OFF

Fan ON

To access the battery compartment, remove

the small Phillips head screw that secures the

battery door to the transmitter assembly. The

battery should be installed with the positive

(+) side up. Replace with a CR2032 battery

when necessary.

Phillips

Head

Screw

Battery

Door

If you are installing multiple remote-controlled fans on

the same circuit breaker, you may need to perform a few

extra steps to prevent interference or faulty operation of

your remote controls.

Go to www.HunterFan.com/FAQs and click

“How do I properly install multiple remote-controlled fans?”

for more information.

Turn P