Turn p ow er, Remote control – Hunter 53258 54 Fallston User Manual

Page 16

www.HunterFan.com

1.888.830.1326

Remote Control

Note: The remote must be paired before

the fan will operate.

Within 3 minutes of restoring power to

the fan, press both the Fan button and the

Light button for at least 4 seconds. Your fan

will turn on to indicate successful syncing.

If it does not, turn off power to your fan,

wait 1 minute then try again. If using the

transmitter with multiple fans, repeat this

process for each fan.

To access the battery compartment, remove

the small Phillips head screw that secures the

battery door to the transmitter assembly. The

battery should be installed with the positive

(+) side up. Replace with a CR2032 battery

when necessary.

Phillips

Head

Screw

Battery

Door

If you are installing multiple remote-controlled fans on

the same circuit breaker, you may need to perform a few

extra steps to prevent interference or faulty operation of

your remote controls.

Go to www.HunterFan.com/FAQs and click

“How do I properly install multiple remote-controlled fans?”

for more information.

Turn P

Fan

Light