Hunter 53214 54 Granville - Manual (Page 16)

www.HunterFan.com
1.888.830.1326
16
M3543-01 • 05/14/14 • © Hunter Fan Company
Remote Control
Note: The remote must be paired before the
fan will operate.
Within 3 minutes of restoring power to the
fan, press both the Fan Off button and the High
button for at least 4 seconds. Your fan will turn on
low to indicate successful syncing. If it does not,
turn off power to your fan, wait 1 minute then try
again. If using the transmitter with multiple fans,
repeat this process for each fan.
Fan Off
High
To access the battery compartment, remove
the small Phillips head screw that secures the
battery door to the transmitter assembly. Install
one (1) 3-Volt, CR2032 battery (included) into the
transmitter. Clean the battery contacts and also those
of the device prior to battery installation. The battery
should be installed with the positive (+) side up.
Please contact your local battery recycling center for
proper battery disposal information.
Phillips
Head
Screw
Battery
Door
ON
Turn P
ow
er
If you are installing multiple remote-controlled fans on
the same circuit breaker, you may need to perform a few
extra steps to prevent interference or faulty operation of
your remote controls.
Go to www.HunterFan.com/FAQs and click
“How do I properly install multiple remote-controlled fans?”
for more information.
This product contains a button battery. If swallowed,
it could cause severe injury or death in just two hours.
Seek medical attention immediately.
CAUTION:
• Always purchase the correct
size and grade of battery most
suitable for the intended use.
• Replace all batteries of a set at
the same time.
• Clean the battery contacts and
also those of the device prior to
battery installation.
• Ensure the batteries are
installed correctly with regard to
polarity (+ and -).
• Remove batteries from equipment
which is not to be used for an
extended period of time.
• Remove used batteries promptly.
16