Light kit – Hunter 59039 54 Windemere User Manual

Page 14

www.HunterFan.com

1.888.830.1326

Light Kit

Make sure the lower switch housing is securely attached to
the upper switch housing. Failure to properly secure all three
assembly screws could result in the light fixture falling.

Partially install two of the switch housing

screws found in the bag. Connect

the plugs from the upper and lower

switch housings. Make sure to line up the

colored markings on the connectors.

Align the keyhole slots in the light kit

housing with the housing assembly

screws. Make sure all the wires from the

fan and the light kit are snug inside the

center of the light kit, not pinched in

between the upper switch housing and
the light kit or hanging out of the sides.

Turn the light kit counterclockwise until

the housing assembly screws are firmly

situated in the narrow end of the keyhole

slots. Install the remaining screw into the

housing. Tighten all three screws securely.

Switch

Housing

Screw

Note: Globe style and number of

lights may vary.