Hunter 59015 52 Altitude - Manual (Page 16)

www.HunterFan.com
1.888.830.1326
16
M3518-01 • 03/07/13 • © Hunter Fan Company
You must remove the wiring harness and its components from the
integrated light fixture. You must then install the wiring harness into the
empty switch housing included with the fan.
• Locate the reversing switch and carefully remove the two screws holding
the reversing switch to the lower switch housing. Now, remove the
reversing switch from the housing.
• Remove the patented breakaway connector from the end of the fan pull
chain. Carefully loosen the bellmouth nut from the pull chain and remove
the pull chain switch from the light fixture housing.
• Locate and carefully remove the two capacitors.
• Unplug the two-wire connectors; one connector will have a black with
white stripe wire and a white wire coming from the multi-wire connector.
You have now disconnected the wiring harness and its components and
are ready to install them into the empty switch housing. (The light switch
remains in the light assembly housing.)
• Insert the pull chain and fan pull chain switch through the round
opening on the side of the empty switch housing. Thread the bellmouth
nut over the pull chain and hand tighten the bellmouth nut.
• Reattach the breakaway connector to the pull chain.
• Insert the reversing switch into the square hole on the side of the switch
housing. Install and tighten the two screws you removed previously from
the other switch housing.
• Carefully place the capacitors in the switch housing.
• Continue with the steps on page 14.
Installation Without a Light Kit
Switch
Housing
Fan
Speed
Switch
Interruptor de
velocidaad del
ventilador
Interruptor
de inversión
Interruptor
de luz
Caja del
conjunto
de luces
Condensadores
Tuercas acampanadas