Hunter 28787 54 Claymore - Manual (Page 15)

15
42653-01 • 12/30/10 • Hunter Fan Company
7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
7-14. To uninstall the light fixture, first disconnect the two pairs of male
and female plug connectors from each other.
7-15. Uninstall the nut and washer from the end of the light
fixture inside the lower switch housing.
7-16. Unscrew the threaded rod of the light fixture from the lower
switch housing.
7-17. Remove the light fixture from the lower switch housing
pulling disconnected wires through the hole in the center of
the lower switch housing.
Note: When removing the wires, pull the thin plug
connector (male) through first, and then pull the other plug
connector (female) through the hole.
7-18. Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the lower switch housing.
7-19. Install the switch housing cap and plug button to the lower
switch housing.
7-20. Once you have uninstalled the light fixture, continue
with step 7-6.
Lower Switch
Housing
Threaded Rod
Plug
Connectors
Step 7-16
Male Dummy
Terminal
Female Dummy
Terminal
Step 7-19
Cap
Plug Button