J&M 1151-22T - Manual (Page 31)

29
SET-UP INSTRUCTIONS (Continued)
Roll Tarps for Grain Carts
Attaching the Canvas Tarp to the Roll Pipe
10
11
Installing Universal and Crank Handle
On the opposite side of the canvas tarp, slide the
1” schedule roll pipe into the remainng sleeve
on the canvas tarp with the spline end towards
the rear of the cart. Line up the spool on the
roll pipe with the spring return on the front of
the grain cart. Drill a hole with a 1/4” drill bit
through each of the stiffening patches and roll
pipe and drill one 1 1/4” from the edge of the
canvas tarp at both ends. (Six holes total). Use
a hammer to install six of the 1/4” drive rivets.
Slip the spring returnloop over the spool. See
the right picture on step 8 for an example of the
stiffening patch.
Front Spring
Return on
Grain cart
Spool on
Roll Pipe
Crank Handle
Install the universal joint using
two 3/8”-16 x 2” hex bolts and
two 3/8”-16 centerlock hex nuts.
Install the tarp crank handle us-
ing one 1/4”-20 x 2 1/2” hex bolt
and one 1/4”-20 centerlock hex
nut.
(Note: Universal joint may be
pre-assembled.)
3/8” x 2”
Universal Joint 1/4”x2 1/2
Use the Hanger Bracket to mark and drill four 3/8” holes on
the rear of the cart as shown above. Make sure the hanger
bracket is as low as possible on the rear wall. Attach the
hanger bracket to the back wall with four 3/8”-16 x 1” ser-
rated flange hex bolts and four 3/8”-16 serrated flange hex
nuts. Use one 1/2”-13 x 1 1/4” hex bolt and one 1/2”-13
centerlock hex nut to bolt the tarp crank handle hanger hook
to the hanger bracket. Do not completely tighten the bolt for
the hanger hook. This hook needs to swing freely.
12
Mounting Crank Handle Bracket and Hook
Hanger Bracket
Hanger Hook
70 1/2” On Center