beautypg.com

6 field operation – J&M PRO 450 User Manual

Page 11

background image

11

OPERATIONS

1.6 Field Operation

WARNING: The Speed Pro must be hooked to the towing vehicle during loading and

unloading.

1.

Position the Speed Pro next to the planter/drill so the auger will reach the planter box.

2.

Start the hydraulic power unit and increase throttle speed. (Allow hydraulic fluid to warm-up.)

(Figure 1.2).

3.

Extend the auger to unload position using the handheld controller/wireless remote.

WARNING: Empty-out the rear compartment first to help prevent the chance of flipping the

Speed Pro.

9.

Use the Handheld Control or Wireless Remote to start the auger.

10.

Fill the planter/drill to desired level then repeat.

NOTE: Adjusting engine throttle will regulate auger speed.

11.

Run the engine at 1/2 to full rpm for 20 minutes to recharge the battery.

12.

Slide the fuel shut off lever to the “OFF” position. This will allow the engine to shutoff by running out

of gas.

13.

Turn the key to the “OFF” position.

M

J

F

E

Conveyer/Auger

Up

Start

Conveyer/Auger

N

E

Blue

F

Yellow

J

Red

M

Green/Black

N

Green

Starts/Stops Motor

Raises/Lowers Conveyer

JM0014984

Reprogramming the Key Fob and Receiver:

To complete the learn procedure, simply do the following. Power up the unit. When you do so, the LED on the

receiver unit will flash “RED” four times. This indicates that the unit has received power. There is magnetically controlled

switching circuitry embedded in the receiver unit. Place a fairly powerful magnet on the back of the receiver for a brief

moment (3 seconds), and the remove it. The LED will go to a constant RED stare. Now immediately press any button on the

transmitter you are attempting to learn in. The LED will go to a GREEN/YELLOW color. This confirms that the receiver

has picked up a signal from the transmitter, and subsequently learned that signal. Communication has been established, and

it is now ready to function properly.

Troubleshooting:

Should the above procedure not complete successfully, wait until the LED light goes out, and repeat the procedure. If for

any reason you experience a second failure of the learn procedure, do the following. Place the magnet on the learn area

and the LED will go to a constant RED stare. Leave the magnet in place on the receiver until the LED light goes out.

(Approximately 10 seconds). This action completely clears the receiver’s memory. Once you have cleared the memory,

proceed with the standard learn procedure detailed above for the key fob transmitters.