J&M 540SD - Manual (Page 10)

Pg. 10
MODEL 540SD and 440SD REPAIR PARTS LIST
Center Diverter Chute Assembly Instructions
1. Locate the plates on both underneath sides of the door. There is a
3/8” tapped hole located on each plate. Attach the Center Diverter
Chute using one 3/8” hex bolt, washer and lock nut as shown.
Insert the 3/8” bolt through the pre-punched hole in the chute. Thread the nut onto the bolt until
approximately half of the threads are exposed. Screw the bolt through the pre-tapped hole in the plate
under the gravity box until the nut is against the plate. This allows the bolt to be used as a pivot so the
center diverter chute can swing freely.
2. Lift the Side Dump Chute up into
storage position. Rotate the Center
Diverter Chute up against the Side
Dump Chute. Extend the chain on the
Center Diverter Chute up to the center
of the Side Dump Chute so the chain is
tight. Mark and drill one 3/8” hole in the
Side Dump Chute and attach the chain
a couple of links from the end using one
3/8” stove bolt and nut. Be sure to
position the head of the stove bolt on
the inside of the Side Dump Chute.
Side Dump
Chute
3/8” Nut
3/8” Bolt
3/8” Tapped Hole
Center Diverter
Chute
Box Plate
Diverter Chute
Attach the chain of
the Center Diverter
Chute to the Side
Dump Chute