J&M 385SD-D - Manual (Page 10)

10
CHUTE, DOOR AND WHEEL ASSEMBLY
# Part # Description Qty
1 D-350 Door 1
D-350D Door only for Divider Box 2
D-350M Metering Door (optional) 1
2 GC-36 Grain Chute 1
3 IW-71212 Inspection Window 2
4 62095-7 Window Molding 2
5 WB-4 Window Brace - Inside 4
6 WB-4B Window Brace - Outside 4
7 TA-2014 Track Assembly 1
8 138RP 1 3/8" Roll Pin 1
9 11T40 11 Tooth Sprocket 1
10 WGA-1034 Welded Guide Assembly 1
11 MC-250 Metal Clip 1
12 GL-250 Galvanized Clip 1
13 DS-250 Door Spring 1
14 WPS-250 Wheel Pin & Strap 1
15 381-HBN-F 3/8" x 1" Bolt w/nut (flange) 4
16 3834-HBN 3/8" x 3/4" Bolt w/nut 8
17 38112BN 3/8" x 1 1/2" Bolt w/nut 1
Installation of Center Dump Chute
Position and secure the Side Dump Chute in the transport position as shown below. Locate the Side Plates on
the left and right sides of the door. There are two pre-drilled holes located on each plate. Attach the ears on
each side of the Center Dump Chute to the outward most pre-drilled hole on the side plate using one 3/8” hex
bolt, washer and lock nut. Insert the S-hook of the center dump chute chain into the inward most hole on each
Side Plate.
Side Dump Chute
in transport position.
Pre-drilled hole located
on each plate to attach
Center Dump Chute.
Center Dump Chute
Insert Chain from
Center Dump Chute
Here.
Side Plate located on
each side of door.