beautypg.com

J&M 620-14 User Manual

Page 12

background image

12

Trouble Shooting

WARNING
MAKE SURE THAT ALL POWER IS SHUT OFF BEFORE SERVICING THE GRAIN CART. MAINTENANCE AND

REPAIR SERVICE WORK TO BE PERFORMED BY QUALIFIED SERVICEMEN ONLY.
Trouble...

Possible Cause...

Possible Remedy...

Auger will not return to down position

or move from stow position.

Dirt in Restrictor (see pg. 14)

Faulty Check Valve

Upper flighting and lower flighting are

locked together (see pg. 14)

Remove restrictor fittings from outside

hydraulic cylinder and clean out dirt

Replace Check Valve

Bearing on top of upper auger flighting

need adjusting. When the auger is in

the engaged position, there must be

1/8” (0,32cm) gap between bottom

of top bearing and top of upper tube

housing (SEE ADJUSTING THE

UPPER AUGER FLIGHTING)

Hanger Bushing Assembly at the top

of the lower auger flighting is hot

Top of the hanger bushing assembly is

rubbing against the drive dog

(See pg.13)

Loosen the two bolts and re-adjust

the position of the hanger bushing

assembly. Re-tighten bolts.

Remove the lower flighting assembly

and place a shim between the spline

coupler and the gearbox.

Excessive Vibration

Auger flighting or shaft is bent

Drive shaft is bent

Straighten or replace auger flighting

Replace or straighten drive shaft

Grain flow stoppage

Bolt sheared in drive dog

Folding auger before complete stop

Replace bolt in drive dog. Engage

upper and lower flighting at a slow rate

of speed. (Drive dogs and lugs are

being engaged too fast.)

Upper and lower flightings are

disengaging before auger comes

to a complete stop. Replace bolt

in the drive dog. Never engage

or disengage the upper and lower

flightings until the augers come to a

complete stop.

Replace key and tighten set screw.

Auger tube is breaking away from the

grain cart at the hinge area or the ram

in the hydraulic folding cylinder is bent

Upper auger is extended in the upright

position while traveling in the field

Repair or replace folding cylinder if

necessary. Remember to lower auger

to the field position after unloading.

PTO key sheared

This manual is related to the following products: