Avanti IMW24 - Manual (Page 11)

11
Operating Instructions
Starting your Ice maker
?
Open the lid and fill the reservoir with water. Make sure the water level in the reservoir is not
over the Ice collecting tray.
?
Press START button to turn unit on.
?
Select desired ice cube size by pressing “ice size” selectors S, M and L.
?
Check the water level in the reservoir periodically. The ice maker will detect any shortage of
water and stop operating. The ALERT indicator will be lit. Press the STOP button and fill the
reservoir with water. W ait 3 minutes after the ALERT light goes out and then press the START
button. The Ice maker will begin operation.
?
When the ice cubes are collected and reaches the bin sensor, the ice maker will stop operating
and the ICE FULL indicator will be lit.
?
There are three sizes of ice cubes available, therefore the larger the ice cube selected, the
longer the time it will take to complete the cycle. When the ambient temperature is lower than
15
°C (59ºF), the small or medium ice cubes sizes are recommended to avoid ice cubes
clumping together.
?
For best performance, water temperature should be between 7
°C (45ºF) and 35°C (95ºF) and
ambient between 15
°C (59ºF) and 25°C (77ºF).
CARE AND MAINTENANCE
? Cleaning Your Ice Maker
?
To ensure the cleanliness of the ice cubes, water in the reservoir should be replaced every 24
hours.
?
If the compressor stops for any reason such as water shortage, too much Ice, power off, etc... Do
not start the system right away, wait 3 minutes, and then re -start the Ice maker.
?
Remove the drain plug to drain remaining water from the water reservoir when the ice maker will not
be used for long period of time. Screw the drain plug back in place after the water has been drained.
?
Always change with fresh water before starting ice production at initial installation or after long
shut-off periods.
?
Please clean your Ice maker regularly. When cleaning, unplug the unit and remove the ice cubes.
Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice
maker. Do not spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil.
Rinse thoroughly before starting.
Caution
Failure to unplug the ice maker could result in electrical shock or personal injury.
? Space Requirements
?
During transportation, the incline angle of the cabinet should not be over 45
°
?
Do not turn the Ice maker upside down. Problems could occur in the compressor and sealed
system.
?
The Ice maker should be placed horizontally on a properly leveled surface.
?
To ensure proper ventilation for your Ice maker allow 6” of space at the top, the back and on each
side.
?
Before using the Ice maker for the first time, please wait 2 hours after positioning it.
?
Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently.
IMPORTANT: Do not install the Ice maker near an oven, radiator, or other heat source.
TEMPERATURE SENSOR