Avanti BD6000 User Manual
Page 23
23
PROBLEMS WITH YOUR BEER DISPENSER?
You can solve many common Beer Dispenser problems easily, saving you the cost of a possible
service call. Try the suggestions below to see if you can solve the problem before calling the servicer.
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE CAUSE
Beer Dispenser does not operate.
Not plugged in.
The circuit breaker tripped or blown fuse.
The temperature control knob is set in “OFF”
position.
Turns on and off frequently.
The room temperature is hotter than normal.
The door is open too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The Beer Dispenser does not have the correct
clearances.
Vibrations.
Check to assure that the Beer Dispenser is
leveled .
The Beer Dispenser seems to make too much
noise.
The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
Beer Dispenser.
Contraction and expansion of the inside walls
may cause popping and cr ackling noises.
The Beer Dispenser is not level ed .
The door will not close properly.
The Beer Dispenser is not level ed .
The door was reversed and not properly installed.
The gasket is dirty.
The shelves or metal plate or beer keg are out of
position.