Castle LB-23 Diagnostics Manual - Manual (Page 20)

2. Once the table is loose, locate the four leveling bolts. There are two on each side of the machine on
the underside of the table.
3. Adjust the bolts up or down and check that the table is level and has the appropriate clearance from
the guard.
4. It is important to maintain the table in the same level position it was in before the adjustment. To
do this, the leveling bolts must be turned the SAME NUMBER OF TURNS AS ONE ANOTHER. It
may be helpful to mark one face of the hex head to use as a reference point as the bolt turns.
5. Retighten the bracket nuts and drill a set of test holes to make sure that the table stayed level.
Revised 2/9/2007