Castle AT-8 Diagnostics Manual User Manual
Page 4
3. Check that the tabletops meet evenly by running your fingers across the seam on the top of the
table. If they don't meet perfectly, gently tap the half that is out of alignment with a rubber mallet.
4. Tighten the tabletop nuts down completely once they are level.
3. Adjust 10 x 1/4 screws that hold the tabletop to the frame.
See also other documents in the category Castle Equipment:
- TSM-12 (23 pages)
- TSM-21 Serial 61064 and lower (Mead) Operator Manual (36 pages)
- TSM-21 Serial 61076 to 64233 (Parker) Operator Manual (36 pages)
- TSM-21 Serial 64234 and above (Bosch) Operator Manual (41 pages)
- TSM-21 Diagnostic Manual (63 pages)
- TSM-21 Adjusting Pressure Regulator (1 page)
- TSM-21 Serial 61064 and lower Assembly Drawing & Parts (9 pages)
- TSM-21 Serial 61076 to 62480 Assembly Drawing & Parts (9 pages)
- TSM-21 Serial 62481 to 64233 Assembly Drawing & Parts (9 pages)
- TSM-21 Serial 64234 and above Assembly Drawing & Parts (8 pages)
- TSM-35 Operator Manual (33 pages)
- TSM-35 Change the Drive Belt (1 page)
- TSM-35 Serial 60343 and lower Assembly Drawing & Parts (12 pages)
- TSM-35 Serial 60344 to 61824 Assembly Drawing & Parts (13 pages)
- TSM-35 Serial 61825 and 63657 Assembly Drawing & Parts (13 pages)
- TSM-35 Serial 63658 and higher Assembly Drawing & Parts (13 pages)
- AT-5 (26 pages)
- AT-8 Operator Manual (30 pages)
- AT-8 AT Clamp Cylinder Detail (4 pages)
- AT-8 AT Clamp Cylinder Rebuild (5 pages)
- AT-8 OB (32 pages)
- TSM-11 (22 pages)
- TSM-20 Operator Manual (7 pages)
- TSM-20 Operator Manual Addendum (10 pages)
- LB-23 Operator Manual (26 pages)
- LB-23 Diagnostics Manual (30 pages)
- 30 Express (20 pages)
- Equalizer Edgebander (28 pages)