Tuff Stuff ECD-44 Chin/Dip/VKR Combo Stand - Manual (Page 6)

6
ECD-44 Preparation & Assembly
Thank you for purchasing the Gladiator ECD-44 Chin/Dip/VKR Stan Combo. This bench is part of the Tuff Stuff
line of quality strength training equipment. To maximize your use of the equipment, please study the Owner’s
Manual thoroughly.
Required Tools
The basic tools that you will need to assemble the ECD-44 but are not
limited to:
• 9/16” , 1/2”, 14mm, and 13mm combination wrenches
• Adjustable wrench
• Ratchet wrench with 9/16” , 1/2”, 14mm, and 13mm
sockets
• Rubber mallet, measuring tape & utility knife
Assembly Requirements
Follow these installation requirements when assemblying the ECD-44.
Use the overhead view on the front page cover to layout your fl oor
plan before assemblying.
Set up the ECD-44 on a clean, solid, fl at surface. A smooth, fl at surface
under the machine helps keep it level.
Allow ample space around the machine for safe unrestricted use and
easier access.
Insert all bolts in the same direction. For aesthetic appearance,
insert all bolts in the same direction unless specifi ed (in text or
illustration) to do otherwise.
Leave room for adjustments. Do not fully tighten fasteners until in-
structed in the assembly steps to do so (to prevent any diffi culty with
alignment of parts during the assembly process). When not instructed,
tighten fasteners such as bolts, nuts and screws so the unit is stable,
but leave room for adjustments.
Assembly Tips
Read all “Notes” on each page before beginning each step.
While you may be able to assemble the ECD-44 using the illustrations
only, IMPORTANT safety notes and other tips are included in the text.
Some pieces may have extra holes that you will not use. Use only
those holes indicated in the instructions and illustration. Safety bolts
(Stopper) are placed in some pieces to prevent accidental removal of
moving parts, be sure to comply with the manufacturer’s request.
NOTE: With so many assembled parts, proper alignment
and adjustment is critical. While tightening the
nuts and bolts, be sure to leave room for fi nal
adjustments.
CAUTION: Obtain assistance if you feel like you can’t assemble
the ECD-44 by yourself. Please do not attempt to
do so as this could result in equipment failure and
injuries to you. Review the installation requirements
before proceeding with the assembly steps.
Maintenance Requirements
Gladiator equipment is designed to off er long-life service and
minimum maintenance. Please refer to the inspection and schedule
replacement part labels posted on the machine or on pages 3-4 of this
manual. Do not use Lysol or Windex as they will dry out and crack the
vinyl. Use a lanolin based hand cleaner or naugahyde cleaner on the
upholstery.
Registration Card
To avoid unnecessary delays on warranty parts and to insure that a
permanent record of your purchase is on fi le with our company, be
sure to mail in the warranty registration card or register online at
www.tuff stuff directonline.com within 10 days of purchase.
Loosely Fasten
Finger tighten all hardware in this step. DO NOT wrench
tighten. Some component(s) may need pre-assembly
and alignment during the assembly process.
Fully Fasten
Wrench tighten all hardware in this step.
SC
RE
W
W
ID
TH
W
AS
HE
R
DI
AM
ET
ER
NU
T D
IA
ME
TE
R
SC
RE
W
LE
NG
TH
ECD-44 Chin/Dip/VKR Stand Combo