Dings Magnetic Group Stationary Electro Overhead Magnets - Manual (Page 4)

Revised January 19, 2011
Unpacking and Handling
Upon receiving, check all packaged material for shortage of parts and possible damage.
Report shortages and damage to the carrier who delivered shipment. The magnet was
shipped fully assembled, ready for operation. Electrical connection is required to a suitable
source of direct current such as a rectifier.
Magnet
This Dings electromagnet was shipped using a pallet or 4” x 6” wooden beams as supports
under the two sides of the magnet. After unloading, the magnet should never be placed
directly on the ground. Rather, wood beams or some other means of support should be placed
beneath the two sides of the magnet box to raise the magnet and belt above the ground.
The magnet should always be moved using the sling assembly provided. Never use a forklift
or other device to lift the magnet from the bottom.
The magnet should be stored indoors prior to installation.
Rectifier
The rectifier is a sensitive piece of electrical equipment. It has been shipped on a separate
pallet to protect it during shipment. Take care not to drop or shake this equipment during
handling.
The rectifier may be left strapped to the pallet while being moved. If it has been removed from
the pallet, make sure it is securely fastened to forklifts or winches for moving.
The rectifier should be stored indoors prior to installation.
2