Daymak Voyager - Manual (Page 12)

www.daymak.com
Page 13
Charging your E-Bike
Charging your e-bike is a simple process. You require the following:
• •
The charger that came with your e-bike A 110V household electrical outlet
Charger Warning
Only use the charger that was supplied with your e-bike. Using a charger which does not have
specifications identical to those which originally came with the e-bike could irreparably damage
your e-bike’s battery and electrical systems, and may cause injury.
To charge your e-bike, follow these steps:
1.
Turn off the e-bike and remove the key from the “ignition”. 2. Plug the female end of the
charger cable into the charging slot on the e-bike. This is
found on the outside casing of the e-bike, in front of and just underneath the seat. 3.
Plug
the male end of the charger power cable into your wall socket. This should be a
110v household electricity supply. You can also use a portable generator, if
necessary, but make sure it provides 110V current. 4.
Allow the e-bike to charge for the
appropriate amount of time (3-8 hours).
You will hear a loud musical tune when you initially start charging. This indicates that
the e-bike is being charged. 5. Disconnect the charger when the LED light on the charger is
green. The battery has
been fully charged.
If you have removed the battery to charge it away from the e-bike, follow the same procedure, but
plug the battery directly into the power supply.
Note If your charger’s LED status light does not change from red to green over an extended
period of time, for perhaps more than 14 hours, and the battery is very hot, the battery or charger
may need replacing. Stop charging and bring both to your Daymak dealer immediately. Do not
charge the battery.