Chenbro SK33502 Installation Guide with 3Gb/s SATA/SAS Backplane - Manual - Manual (Page 7)

7
SK33502 ver. B0
User’s Manual
www
.chenbr
o.com
15Fl., No.150, Jian Yi Road, Chung Ho City, Taipei Hsien, Taiwan R.O.C.,
Tel: +886 2 82265500 Fax: +886 2 82265392 Email: [email protected]
Introduction
The CHENBRO SK33502 can house five 3.5” HDDs in a three 5.25” bays converter (Depth of 9.5”
recommended). The ability for conversion allows existing servers to perform the maximum HDD density
while keeping the flexibility. In all, SK33502 is the best solution as value added feature and performance.
Functional Specification
General
z Support SAS and SATA-II (3Gb/s)
z Compatible with 3.5” SATA-I, SATA-II and SAS HDD
z Support inrush current control for drive hot-swapping
z LED indicate activity and failure for each HDD
z Alternative HDD activity and failure signal source
Host / Drive / Power Interfaces
z Direct link SAS / SATA ports
z 5 x SATA Signal + Power (7+15 pin) jacks at HDD side of backplane
z 5 x SATA jacks (7 pin) at host side of backplane
z 2 x DC power jacks (4-pin D-type)
Monitoring Function
z 1 x Fan 3P3C jack with speed monitoring
z Fan monitoring can be disabled
z 2 x temperature sensors for HDD overheating monitoring
z Overheat temperature is selectable：55℃ or 65℃
z Support one buzzer for audible alarm, three fail LED output for fan / overheat / HDD failure events, one
alarm mute button for disabling audible alarm
z Alarm mute & LED outputs are connected through 2 x 7 pin header (pitch=2.54mm) with 1 key pin to the
LED board