AmeriHome BS2091 Bar Stool - Manual (Page 2)

A Black Cap protects the
hydraulic mechanism on
the Support Cylinder.
Place the Foot Cap
over the Footrest.
Remove the Black Cap and
discard it before assembly.
The Orange hydraulic
button will become visible.
Insert the Support Cylinder
into the center of the Seat
Plate
Insert the Support
Cylinder into the center
hole of the Footrest
Press down firmly
on seat to secure
into base.
ASSEMBLY INSTRUCTION
To raise and lower the Seat, grasp the Handle and pull upward without applying any weight on the
Seat. To lower, raise the Handle upward by sitting on the Seat.
To disassemble, turn the stool upside down,
and hit the metal clip on the center of the
bottom of the Footrest with a rubber mallet
to disengage the locking mechanism. Then,
turn the stool right side up, and lift the Seat
upward, pulling the Seat Assembly off of the
Footrest.
To separate the Support Cylinder from the Seat, gently strike the Seat Plate with a
rubber mallet until the Seat and Support Cylinder have separated.
Use an allen wrench to attach the
Seat Plate to the underside of the
Seat with the provided Screws.
Metal Clip