AmeriHome BABBS2 Bamboo Bar Stools - Manual (Page 4)

ASSEMBLY
COMMON SENSE AND CAUTION ARE FACTORS WHICH CANNOT BE BUILT INTO ANY PRODUCT.
THESE FACTORS MUST BE SUPPLIED BY THE OPERATOR.
On initial assembly, do not tighten screws completely until assembly is completed.
ASSEMBLING THE BAR
M8x140
Bolt
M8x140
Bolt
M8x120 Bolt
M8x140
Bolt
M8x120 Bolt
Assemble the bar by following the diagrams below.
Figure 1
Start with the Front Panel
(#9) and attach the two
Shelf Supports (#14)
Figure 2
Add the two Side Panels
(#6) and secure with the
M8x140 bolts.
Figure 3
Attach the Counter Top (#5)
and attach the Top Shelf
(#7) and Bottom Shelf (#8)
Figure 4
M8x170 Bolts
Install the two Vertical
Supports (#4). The Vertical
Support is forked and
attaches to the Side Panels
using two M8x110 bolts.
Figure 5
M8x110
Bolts
M8x110
Bolts
Install the Support Beam
(#3) on top of the Vertical
Support. Place the Top Roof
Panels (#2) on top, then
secure the Crown (#1). Figure 6
Add the Hanging Rack
(#13), then tighten all bolts
and screws to secure the
Bamboo Bar.
BABBRC Bamboo Bar Set Assembly & Operating Instructions
4