BlueBird S530B_968999683 - Manual (Page 24)

24 - BLUEBIRD
Clutch Cable
Removal and Replacement
Turn off engine and remove old clutch cable. 1.
Route new cable through the hole at the rear of 2.
housing.
Attach clutch cable to the bracket on the spring
3.
on the idler assembly, then connect opposite end
of cable to the S hook.
Adjust cable to obtain ¾" to 1¼" extension of the
4.
clutch spring when clutch is engaged.
8060-002
Route clutch cable through guides
8060-013
Adjust cable
Throttle Cable
Removal and Replacement
Before removing your old cable measure the 1.
amount of cable extending past the cable screw.
Remove the old throttle cable and route the new
2.
cable through the guide hole at the rear of the
housing.
Insert the new cable through the cable screw to
3.
the measurement obtained in step 1 and tighten.
Attach the new adjuster bracket to the spring on
4.
the throttle/clutch lever.
MAIntenAnCe AnD seRVICe