Indesit HIM 50 K.A IX User Manual

Page 4

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load
indicated on the data plate (see side).
The appliance must be directly connected to the
mains using an omnipolar circuit-breaker with a
minimum contact opening of 3 mm installed between
the appliance and the mains, suitable for the load
indicated and complying with current electrical
regulations (the earthing wire must not be interrupted
by the circuit-breaker). The supply cable must not
come into contact with surfaces with temperatures
higher than 50°C.

! The installer must ensure that the correct electrical
connection has been made and that it is compliant
with safety regulations.

Before connecting to the power supply, make sure that:

• The appliance is earthed and the plug is compliant

with the law.

• The socket can withstand the maximum power of

the appliance, which is indicated on the data plate
(see below).

• The voltage must be in the range between the

values indicated on the data plate (see below).

• The socket is compatible with the plug of the

appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.

! Once the appliance has been installed, the power
supply cable and the electrical socket must be easily
accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced
by authorised technicians only (see Assistance).

! The manufacturer declines any liability should
these safety measures not be observed.

DATA PLATE

Dimensions

width 43.5 cm
height 32 cm
depth 40 cm

Volume

lt. 56

Electrical
connections

voltage: 230V/400V~ 3N 50/60Hz
maximum power absorbed 8450W

ENERGY LABEL

Directive 2002/40/EC on the label
of electric ovens.
Standard EN 50304

Energy consumption for Forced
convection heating mode:
Multi-cooking
Declared energy consumption for
Natural convection Class heating
mode: Convection

This appliance conforms to the
following European Economic
Community directives:
- 2006/95/EEC of 12/12/06 (Low
Voltage) and subsequent
amendments;
- 2004/108/EEC of 15/12/04
(Electromagnetic Compatibility) and
subsequent amendments;
- 93/68/EEC of 22/07/93 and
subsequent amendments.
- 2002/96/EC and subsequent
amendments.