Associated Equipment 6010A - Manual (Page 4)

CAUTION: AS THE SULFATION BREAKS DOWN, THE AMPERAGE MAY RAPIDLY RISE. CONSTANT
ATTENTION MUST BE OBSERVED TO PREVENT SERIOUS OVERHEATING OF THE BATTERY.
4. Lower the charge rate to the lowest rate for the voltage of battery being charged.
5. Charge the battery at this low rate until the electrolyte reaches the fully charged state as described in the tables in your instruction
manual. This may take as long as two or three days.
NOTE:
SOME BATTERIES MAY BE SO BADLY SULFATED THEY CAN NOT BE RESTORED TO A NORMAL OPERATING CONDITION,
REGARDLESS OF THE RATE OF CHARGE OR THE LENGTH OF TIME THE CHARGE IS APPLIED. IF THE BATTERY CANNOT
BE RESTORED TO A FULLY CHARGED CONDITION BY A SLOW CHARGING, IT SHOULD BE REPLACED.
WIRING DIAGRAM
AMMETER
WHITE
BLACK
FAN
YELLOW
PROBE
STOP/GO LITE
STOP/GO LITE
NEGATIVE
CLAMP
(BLACK)
BLUE
THERMAL
FUSE
POSITIVE
CLAMP
(RED)
CIRCUIT
BREAKER
RESISTOR
RECTIFIER
TRANSFORMER
3
2
1
BL
ACK
BL
ACK
WHITE
Y
E
LLO
W
6 5 4
TIMER
BL
ACK
G
R
EEN
WH
IT
E
6
2
4
RED
WHITE
VIOLET
1
8
VOLTS
CHARGE
SWITCH
MODEL 6010A PARTS LIST
Item Description Part No.
4
1 Transformer......................................................... 611261
2 Rectifier ............................................................... 610364
3 Fan
Blade............................................................ 610189
4 Fan Motor............................................................ 610190
5 Timer ................................................................... 611245
6
Switch w/knob (1)................................................ 611187
7 Amps Charge Meter ............................................ 605204
8 AC Cord .............................................................. 611262
9 DC Cable set....................................................... 611134
10 DC Circuit Breaker (1)......................................... 610069
11 Front/Base/Back Panel ....................................... 611135
12 Stop/Go Lite ........................................................ 604579
13 Clamps (1 pair, includes jaws) ................................ 6202
14 Jaw Kit (repairs 1 clamp)..................................... 610970
15 Knob (1) .............................................................. 603147
Not shown
Top Panel............................................................ 611025
Side Panel (2) ..................................................... 610071
Handle................................................................. 610057
14
9
13
2
6
8
1
3
4
5
7
10
12
11
15
MAINTENANCE INSTRUCTIONS
Worn clamps and jaws should be replaced. Worn parts can lead to poor connections and present a safety hazard. See parts list for part number of
jaw and clamp kits. Any Maintenance or repair of this unit that involves disassembly of the cabinet should be done only by a qualified serviceman.
Incorrect reassembly may result in a risk of electric shock when the unit is subsequently used.
ASSOCIATED EQUIPMENT CORPORATION
5043 FARLIN AVENUE ST. LOUIS, MO 63115
TEL. (314)385-5178 FAX. (314)385-3254
www.associatedequip.com
W1726 027-0336 REV.
20120112