AEG A92708GNW0 - Manual (Page 32)

7.2 Location
50 mm To ensure best performance, if the appli-
ance is positioned below an overhang-
ing wall unit, the minimum distance be-
tween the top of the cabinet and the
wall unit must be at least 40 mm . Ideally,
however, the appliance should not be
positioned below overhanging wall units.
The ventilation space can be:
• directly above the appliance
• behind and above the top cupboard.
In this case, the space behind the top
cupboard must be at least 50 mm
deep.
7.3 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.
7.4 Removing the transport support
2
3
Your appliance is equipped with trans-
port support to secure the door during
transportation.
To remove them do these steps:
• Open the door.
• Remove the transport support from
the door sides.
• Remove the transport support from
the lower hinge (some models).
Some models are fitted with a si-
lencing pad under the cabinet.
Do not remove this pad.
32 www.aeg.com