ABUS TV7512 - Manual (Page 21)

21
2. Connect the video cable (recommended cable type: RG59) with the
BNC video output (1) of the camera and with the output of the camera
as the next connected device.
The maximum cable length must not exceed 100 m.
3. Connect a 12V DC voltage supply to the power input of the camera (2).
4. Hold the camera at the location where you want to mount it later. Check
the orientation and angle of the camera.
5. Fasten the supplied wall or ceiling mount to the desired installation
location and screw the mount into the camera housing.
6. Change the orientation of the camera holder if necessary by slightly
loosening the fixing screw (B/C) and changing the position as required.
Then tighten the fixing screw so that the camera remains in the desired
position.