AAEON FSB-G41H User Manual

Page 62

F u l l - s i z e S B C

F S B - G 4 1 H

Chapter 4 Driver Installation

4-4

The following details the installation of the drivers while installing

Windows XP/ 2000.

When you start installing Windows XP and older operating

systems, you may encounter a message stating, “Setup could

not determine the type of one or more mass storage devices

installed in your system”. If this is the case, then you are

already in the right place and are ready to supply the driver. If

this is not the case, then press F6 when prompted at the

beginning of Windows setup.

Press the “S” key to select “Specify Additional Device”.

You should be prompted to insert a floppy disk containing the

Intel

RAID driver into the A: drive.

Note: For Windows Vista you can use Floppy, CD/DVD or USB.

-----------------------------------------------------------------------------------------

Important
Please follow the instruction below to make an “Intel

RAID Driver”

for yourself.

1. Insert the AAEON CD into the CD-ROM drive
2. Click the “Browse CD” on the Setup screen
3. Copy all the contents in \\Step4 - RAID\F6 Install

Floppy\32bit or 64bit to a formatted floppy diskette

4. The driver diskette for Intel

ICH10DO RAID Controller is

done

-----------------------------------------------------------------------------------------

For Windows Vista:

1. During the Operating system installation, after selecting the

location to install Vista click on “Load Driver” button to install a

third party SCSI or RAID driver.