AAEON PFM-541I User Manual
Page 22
P C / 1 0 4 C P U M o d u l e
P F M - 5 4 1 I
Chapter 2 Quick Installation Guide
2 - 10
CN17 Ethernet
Connector
BAT1 Battery
Connector
CFD1
Type1 Compact Flash Slot
2.7 Setting Jumpers
You configure your card to match the needs of your application by
setting jumpers. A jumper is the simplest kind of electric switch. It
consists of two metal pins and a small metal clip (often protected by
a plastic cover) that slides over the pins to connect them. To “close”
a jumper you connect the pins with the clip.
To “open” a jumper you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2 and 3. In this case you would connect
either pins 1 and 2 or 2 and 3.
1 2
3
Open C
ed C
2-3
los
losed
OFF
ON
ON 2-3
A pair of needle-nose pliers may be helpful when working with
jumpers. If you have any doubts about the best hardware
configuration for your application, contact your local distributor or
sales representative before you make any change. Generally, you
simply need a standard cable to make most connections.