AEG A71100TSW0 - Manual (Page 28)

Problem Possible cause Solution
The appliance does
not cool at all Plug is not connected to
the mains socket properly Connect the mains plug
properly
There is no voltage in the
mains socket (try to con-
nect another appliance
into it) Call an electrician
The appliance is not
switched on Switch on the appliance
Temperature Regulator is
not on Check the Temperature
Regulator
Green indicator
flashing Temperature sensor
problem Call the service personnel
8.1 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
9. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor (garage or cellar)
also, but for optimum performance in-
stall this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
9.2 Levelling
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.
28 www.aeg.com