Franklin Fueling Systems TSA Upgrade - Manual (Page 3)

3
Refresh will display the last DTU signal quality status data.
Start Continuous will stream the data.
Append to Log will begin logging the data.
Setup Tab
The setup tab is used to manually and automatically
download the system setup. The TSA Upgrade Tool will
download the setup automatically when you query a
specific Controller Serial Number. The setup is saved to a
different folder for each serial number in \My Documents\
TSA Upgrade Tool. The upgrade tool will only automatically
download the setup file if the folder and file does not
already exist. You can manually save the setup at any
time you are connected to a console and make a comment
about that setup file. It will also be saved in the same
folder as the automatically saved setup using a date and
time stamp for the file name.
Save will manually save the setup information.
Restore will upload the highlighted setup into the console.
Edit will allow you to edit the comment for the highlighted
setup.
Delete will remove the highlighted setup.
VRM Tab
The VRM tab is used to log A / L data for a site. The output
for the data log will be posted in a different folder for each
specific Controller Serial Number under \ My Document \
TSA Upgrade Tool with a file name of VRM Status Log.
Refresh will display the last A/L data.
Start Continuous will stream the data.
Log Transactions will begin logging the data.
Upgrade Notes
- When the T5 console 4-20 mA module is upgraded the
lines MUST be relearned if the current version is less
than 0.5.3. Lines and SCM containments do not need to
be relearned if it is 0.5.3 or greater.
- If you choose to upgrade all of the modules that are
available for upgrade allow yourself enough time.
- Do not attempt to cycle power to the gauge or your
computer until you see the status ready indication on
the TSA Upgrade program.