GEARENCH SCT1020H PETOL SURGRIP Casing Tong - Manual (Page 11)

9
Torque capacity
The Surgrip Casing Tong utilizes a different belt for each nominal diameter. The maximum
working loads are shown in the table below.
Diameter
Belt
Part
Number
Torque
Arm
Length
(inches)
Maximum
Torque
(foot-pounds)
Maximum
Line Pull
(pounds)
9 5/8 SCTB1020H-0958 43.81 70,000 19,200
9 7/8 SCTB1020H-0978 43.94 70,600 19,300
10 SCTB1020H-1000 44.00 70,900 19,300
10 3/4 SCTB1020H-1034 44.38 72,800 19,700
11 3/4 SCTB1020H-1134 44.88 75,300 20,100
12 1/4 SCTB1020H-1214 45.13 76,600 20,400
13 3/8 SCTB1020H-1338 45.69 79,400 20,900
13 5/8 SCTB1020H-1358 45.81 80,100 21,000
14 SCTB1020H-1400 46.00 81,000 21,100
15 SCTB1020H-1500 46.50 83,500 21,500
16 SCTB1020H-1600 47.00 86,000 22,000
18 SCTB1020H-1800 48.00 91,100 22,800
18 3/8 SCTB1020H-1838 48.19 92,000 22,900
18 5/8 SCTB1020H-1858 48.31 92,600 23,000
20 SCTB1020H-2000 49.00 96,100 23,500
WARNING: Under no circumstances should the maximum working load be
exceeded. Always use a load cell or other calibrated indicating device to monitor
the line pull on the tong to avoid an overload.
Use on couplings
The jaw has two belt anchoring holes. One hole is marked “PIPE”, when this hole is fixed to
the handle, the tong will latch on the pipe for the appropriate belt. The third hole is marked
“COUPLING”, this hole will allow the tong to be latched onto a coupling with a diameter of
one inch over the pipe diameter.