GEARENCH LA116-23 PETOL Bull Tong - Manual (Page 7)

5
Safety Goggles must always be worn by persons in any area where hand and powered tools
are being used.
Never apply excess leverage to a wrench or tool by means of a "Cheater Bar". Never strike
wrenches and tools with hammers or other objects.
All tools should be kept clean, inspected on a regular basis, and replaced when they show
signs of wear.
Be especially careful not to place yourself in a position that could result in bodily injury in
the event of a failure. Brace yourself firmly and pull rather than push when wrenching. (If
necessary to push, do so with the flat of the hand rather than gripping around the wrench.)
Never stand under or near loads being hoisted off the ground.
READ SAFE PRACTICES AND PROCEDURES MANUAL, CATALOG INFORMATION
AND PRODUCT LABELING PRIOR TO OPERATION.
Spinning and drill pipe chain, cathead chain, and the PETOL Connecting Link attachment are
designed for the specific purpose for which the name indicates. Chains and attachments that
are to be used for any other purpose should be selected in accordance with the
recommendations of ASTM, NACM, Rigger's Handbook, and the commercial chain
manufacturer's technical manuals.
Safety Sources and Publications
In the interest of Safety the following sources of Safety information is furnished:
The Hand Tools Institute (HTI)
25 North Broadway
Tarrytown, New York 10591
(914) 332-0040
www.hti.org
The National Safety Council (NSC)
1121 Spring Lake Drive
Itasca, Illinois 60143-3201
(630) 285-1121
www.nsc.org
International Safety Council
1121 Spring Lake Drive
Itasca, Illinois 60143-3201
(630) 285-1121