Elmo Rietschle V-DTA 60/80/100/140 - Manual (Page 27)

27 www.gd-elmorietschle.com © Gardner Denver Schopfheim GmbH, Gardner Denver Deutschland GmbH |
Malfunctions: Causes and elimination
Fault Cause Troubleshooting Important
Final pressure (max.
overpressure) is not
reached Machine or system leaking Check the pipework and
screw connections for leaks
and to ensure that they are
fi rmly seated. Section 7.2
Discs are worn or damaged Replace discs Section 7.2.2
Section 7.4
Driving power selection too
low Use next largest motor output Data sheet
D 361
Machine gets too hot Ambient or intake temperature
is too high Ensure it is being used prop-
erly Section 2.3
Cooling air supply is ob-
structed Check environmental condi-
tions Section 5.1
Clean ventilation slots Section 7.2
The blow out fi lter cartridge
(accessory) is dirty. Clean or replace the fi lter
cartridges Section 7.2.3
Section 7.4
The regulating valve is dirty so
that the permissible pressure
value is exceeded. Clean or replace the regulat-
ing valve Section 7.2
Section 7.4
The machine makes
a abnormal noise The coupling rubbers are
worn Replace coupling rubbers Section 7.2.4
Section 7.4
The compressor housing is
worn (chatter marks) Repair by manufacturer or
authorised workshop Elmo Rietschle
Service
The regulating valve is vibrat-
ing Replace the valve Section 7.4
Discs are damaged Replace discs Section 7.2.2
Section 7.4
Please contact Elmo Rietschle Service for other malfunctions or those that cannot be eliminated.