Gorman-Rupp Pumps 2D-E.50 3P 1467825 and up - Manual (Page 12)

D SERIES OM−01477
PAGE B − 5 INSTALLATION
matches the pump motor requirements stamped
on the motor nameplate.
The electrical power used to operate
this pump is high enough to cause inju-
ry or death. Obtain the services of a qu-
alified electrician to make all electrical
connections. Make certain the pump
and motor are properly grounded; never
use gas pipe as an electrical ground. Be
sure that the incoming power matches
the voltage and phase of the motor be-
fore making motor connections. Do not
run the pump if the voltage is not within
limits.
Do not install and operate a non-explo-
sion proof motor in an explosive atmo-
sphere. Install, connect, and operate
the motor in accordance with The Na-
tional Electric Code and all local codes.
If there is a conflict between the instruc-
tions in the manual accompanying the
unit and The National Electric Code or
the applicable local code, The National
or local code shall take precedence.
Refer to the following motor data before making
electrical connections.
Motor Data
VOLTAGE PHASE HP Hz RPM
230/460 3 .50 60 1750
MODEL
2D−E.50 3P