Gorman-Rupp Pumps VG1 1/4B3-B 1260463 and up - Manual (Page 16)

OM−03289 VG SERIES
PAGE B − 9 INSTALLATION
ELECTRICAL CONNECTIONS
Before connecting a motor to the incoming power,
check that the electrical service available matches
the pump motor requirements stamped on the mo-
tor nameplate.
If rotation is incorrect on a three-phase motor, have
a qualified electrician interchange any two of the
three phase wires to change direction. If rotation is
incorrect on a single-phase motor, consult the lit-
erature supplied with the motor for specific instruc-
tions.
The electrical power used to operate the
pump is high enough to cause injury or
death. Obtain the services of a qualified
electrician to make all electrical con-
nections.
Do not install and operate a non-explo-
sion proof motor in an explosive atmo-
sphere. Install, connect, and operate
the motor in accordance with The Na-
tional Electric Code and all local codes.
If there is a conflict between the instruc-
tions in the manual accompanying the
unit and The National Electric Code or
the applicable local code, The National
or local code shall take precedence.