Gorman-Rupp Pumps VGH1 1/4B31-B 1379872 thru 1210317 - Manual (Page 6)

VGH SERIES OM−06112
PAGE A − 1 SAFETY
SAFETY - SECTION A
This information applies to VGH Series
basic pumps. Gorman-Rupp has no
control over or particular knowledge of
the power source which will be used.
Refer to the manual accompanying the
power source before attempting to be-
gin operation.
Because pump installations are seldom
identical, this manual cannot possibly
provide detailed instructions and pre-
cautions for each specific application.
Therefore, it is the owner/installer’s re-
sponsibility to ensure that applications
not addressed in this manual are per-
formed only after establishing that nei-
ther operator safety nor pump integrity
are compromised by the installation.
Before attempting to open or service the
pump:
1. Familiarize yourself with this man-
ual.
2. Lock out or disconnect the power
source to ensure that the pump will
remain inoperative.
3. Allow the pump to completely cool
if overheated.
4. Check the temperature before
opening any covers, plates, or
plugs.
5. Close the suction and discharge
valves.
6. Vent the pump slowly and cau-
tiously.
7. Drain the pump.
This pump is designed to handle clear
liquids that do not contain large en-
trained solids. Only the Gorman-Rupp
Company or an authorized Gorman-
Rupp distributor may modify a pump or
approve its use for handling volatile,
flammable liquids. If the pump is used
for handling volatile, flammable liquids,
all drivers and/or controls must meet in-
dustry standards and codes for use in
an explosive atmosphere. Do not at-
tempt to pump liquids for which the
pump, driver and/or controls have not
been approved, or which may damage
the pump or endanger personnel as a
result of pump failure.
If this pump has been approved for use
with volatile and/or flammable liquids,
be certain proper safety practices are
followed before operating or servicing
the pump. Provide adequate ventilation,
prohibit smoking, wear static-resistant
clothing and shoes. Clean up all fuel
spills immediately after occurrence.
Do not install and operate a non-explo-
sion proof motor in an explosive atmo-
sphere. Install, connect, and operate
the motor in accordance with the Na-
tional Electric Code and all local codes.
If there is a conflict between the instruc-
tions in the manual accompanying the
unit and the National Electric Code or
the applicable local code, the National
or local code shall take precedence.