beautypg.com

Gorman-Rupp Pumps 02K31-B 597564 and up User Manual

Page 25

background image

0 SERIES

OM-01168

MAINTENANCE & REPAIR

PAGE E - 6

flammable. Use them only in a well ven­
tilated area free from excessive heat,
sparks, and flame. Read and follow all
precautions printed on solvent contain­
ers.

Clean the bearings thoroughly in fresh cleaning
solvent. Dry the bearings with filtered compressed
air and coat with light oil.

The bearings must be kept free of all dirt
and foreign material. Failure to do so will
greatly shorten bearing life. Do not spin
dry bearings. This may scratch the balls or
races and cause premature bearing fail­
ure.

Rotate the bearings by hand to check for rough­
ness or binding. If rotation is rough, replace the
bearings.

The bearing tolerances provide a tight press fit
onto the shaft and a snug slip fit into the bearing
housing. Replace the bearings, shaft, or bearing
housing if the proper bearing fit is not achieved.

If bearing replacement is required, use a suitable
puller or an arbor (or hydraulic) press to remove
the bearings from the impeller shaft.

Shaft and Bearing Reassembly and Installation

Clean and inspect the bearings as indicated in
Shaft and Bearing Removal and Disassembly.

To prevent damage during removal from
the shaft, it is recommended that the bear­
ings be cleaned and inspected in place. It
is strongly recommended that the bear­
ings be replaced any time the shaft and
bearings are removed.

Inspect the shaft for distortion, nicks or scratches
or damage. Dress small nicks and burrs with a fine
file or emery cloth. Replace the shaft if defective.

The bearings may be heated to ease installation.
An induction heater, hot oil bath, electric oven, or
hot plate may be used to heat the bearings. Bear­
ings should never be heated with a direct flame or
directly on a hot plate.

NOTE

If a hot oil bath is used to heat the bearings, both the
oil and the container must be absolutely clean. If
the oil has been previously used, it must be thor­
oughly
filtered.

Heat the bearings to a uniform temperature no
higher than
250

_F (120_C), and slide the bearings

onto the shaft one at a time until they are fully
seated against the shaft shoulders. This should be
done quickly, in one continuous motion, to prevent
the bearings from cooling and sticking on the shaft.

Use caution when handling hot bear­
ings to prevent burns.

After the bearings have been installed and allowed
to cool, check to ensure that they have not moved
out of position in shrinking. If movement has oc­
curred, use a suitably sized sleeve and a press to
reposition the bearings.

If heating the bearings is not practical, use a suit­
ably sized sleeve and an arbor (or hydraulic) press
to install the bearings onto the shaft.

When installing the bearings onto the
shaft, never press or hit against the outer
race, balls, or ball cage. Press only on the
inner race.

Slide the shaft and assembled bearings into the
bearing housing until the inboard bearing is fully
seated against the bore shoulder.

When installing the shaft and bearings into
the bearing bore, push against the outer
race. Never hit the balls or ball cage.