Gorman-Rupp Pumps 83B31-B 1364724 and up - Manual (Page 28)

OM−06007 80 SERIES
MAINTENANCE & REPAIR PAGE E − 7
Replace the bearings, shaft, or pedestal if the
proper bearing fit is not achieved.
If bearing replacement is required, use a bearing
puller to remove the inboard and outboard bear-
ings from the impeller shaft.
Shaft And Bearing Reassembly
And Installation
Clean and inspect the bearings as indicated in
Shaft and Bearing Removal and Disassembly.
To prevent damage during removal from
the shaft, it is recommended that bearings
be cleaned and inspected in place. It is
strongly recommended that the bearings
be replaced any time the shaft and and
bearings are removed.
The bearings may be heated to ease installation.
An induction heater, hot oil bath, electric oven, or
hot plate may be used to heat the bearings. Bear-
ings should never be heated with a direct flame or
directly on a hot plate.
NOTE
If a hot oil bath is used to heat the bearings, both the
oil and the container must be absolutely clean. If
the oil has been previously used, it must be thor-
oughly filtered.
Heat the bearings to a uniform temperature no
higher than 250
_F (120_C), and slide the bearings
onto the shaft, one at a time, until they are fully
seated. This should be done quickly, in one con-
tinuous motion, to prevent the bearings from cool-
ing and sticking on the shaft.
Use caution when handling hot bear-
ings to prevent burns.
After the bearings have been installed and allowed
to cool, check to ensure that they have not moved
out of position in shrinking. If movement has oc-
curred, use a suitably sized sleeve and a press to
reposition the bearings.
If heating the bearings is not practical, use a suit-
ably sized sleeve and an arbor (or hydraulic) press
to install the bearings on the shaft.
When installing the bearings onto the
shaft, never press or hit against the outer
race, balls, or ball cage. Press only on the
inner race.
Slide the shaft and assembled bearings into the
pedestal until the inboard bearing is fully seated
against the bore shoulder.
When installing the shaft and bearings into
the bearing bore, push against the outer
race. Never hit the balls or ball cage.
Position the the oil seal (15) in the pedestal bore
with the lip positioned as shown in Figure 1. Press
the oil seal into the pedestal until fully seated.
Position the the oil seal (23) in the pedestal bore
with the lip positioned as shown in Figure 1. Press
the oil seal into the pedestal until fully seated. Re-
place the bearing retainer O-ring (21) in the pedes-
tal, and lubricate it with grease. Press the bearing
retainer into the pedestal until it seats against the
bearing. Be careful not to roll or cut the oil seal lip
on the shaft keyway. Be sure the setscrews (24) in
the bearing retainer are positioned horizontally in-
line.
Install the same thickness of bearing adjusting
shims (27) as previously removed. Reinstall the re-
taining ring (22) and check shaft endplay.
NOTE
Shaft endplay should be between .002 and .005
inch (0,05 to 0,12 mm). Add or remove bearing ad-
justing shims to obtain this endplay.
Install the slinger ring (14) and shaft key (25). Install
any leveling shims used under the pedestal feet.