Gorman-Rupp Pumps 83A3-B 734045 and up - Manual (Page 31)

OM−00862 80 SERIES
MAINTENANCE & REPAIR PAGE E − 9
This seal is not designed for operation at
temperatures above 160
_F (71_C). Do not
use at higher operating temperatures.
If the seal plate (9) was removed, lay it on a flat sur-
face with the impeller side facing up. Subassemble
the stationary element into the stationary seat and
press this subassembly into the seal plate bore un-
til fully seated.
Slide the assembled seal plate and stationary por-
tion of the seal over the shaft (22) and temporarily
secure the seal plate to the pedestal (14) using two
capscrews and nuts (1/2 UNC X 1 1/2 inch long,
not supplied).
Subassemble the rotating element into the retainer
and bellows, then slide this subassembly onto the
shaft sleeve (10) until the face of the rotating ele-
ment is just flush with the chamfered end of the
sleeve.
Slide the assembled seal and shaft sleeve onto the
shaft until the seal faces contact. Continue to push
the sleeve through the seal until the chamfered end
seats firmly against the shaft shoulder.
Install the seal spring and spring seat (52).
Impeller Installation and Adjustment
Inspect the impeller, and replace it if cracked or
badly worn. Install the same thickness of impeller
shims (51) as previously removed, and screw the
impeller onto the shaft until tight.
A clearance of .010 to .020 inch (0,25 to 0,51 mm)
between the impeller and the seal plate is neces-
sary for maximum pump efficiency. Measure this
clearance and add or remove impeller shims until
this clearance is reached.
NOTE
Be sure the seal plate is tight against the pedestal
while measuring this clearance.
After the back clearance is set, secure the impeller
with the hardware (31, 32 and 33).
Pump Casing Installation
If the wear plate assembly (34) was removed, posi-
tion the replacement wear plate assembly squarely
against the casing shoulder and secure it with the
mounting hardware (35, 36, 38 and 39). Replace
the fiber washer (39) if badly worn or compressed.
Remove the hardware temporarily securing the
seal plate to the pedestal. Install the same thick-
ness of pump casing gaskets (30) as previously re-
moved. Secure the pump casing (1) to the seal
plate and pedestal with the nuts (29).
A clearance of .008 to .015 inch (0,20 to 0,38 mm)
between the impeller and the wear plate is also rec-
ommended for maximum pump efficiency. Set this
clearance by adding or removing gaskets in the
pump casing gasket set (30) until the impeller
scrapes against the wear plate when the shaft is
turned by hand. After the impeller scrapes, add ap-
proximately .008 inch (0,20 mm) of gaskets.
Secure the pump casing to the base with the pre-
viously removed hardware. Be sure to reinstall any
leveling shims used under the mounting feet of the
pump casing.
If a lifting eye was used to move the pump casing,
be sure to remove the lifting eye from the pump
casing.
Do not attempt to lift the complete pump
unit using the lifting eye. It is designed
to facilitate removal or installation of in-
dividual components only. Additional
weight may result in damage to the
pump or failure of the eye bolt.
Suction Check Valve Installation
Inspect components of the check valve assembly
(42) and replace as required. If separated at disas-
sembly, assemble the check valve weights (43 and
45) to the check valve gasket (44) with the hard-
ware (46 and 47).