beautypg.com

Gorman-Rupp Pumps 81 1/2E3-B 341115 and up User Manual

Page 26

background image

80 SERIES

OM−00766

MAINTENANCE & REPAIR

PAGE E − 8

INTERMEDIATE

IMPELLER
SHAFT

STATIONARY
SEAT

STATIONARY
ELEMENT

ROTATING
ELEMENT

DRIVE BAND

IMPELLER
SHIMS

IMPELLER

SPRING
SEAT

RETAINER

SEAL
WASHER

BELLOWS

SPRING

Figure 3. 25271−821 Seal Assembly

This seal is not designed for operation at
temperatures above 160

_ F (71_ C). Do

not use at higher operating temperatures.

Install the stationary seat element in the stationary
seat. Use your thumbs to press this subassembly
into the seal bore in the intermediate until fully and
squarely seated in the seal plate bore. After instal-
lation, wipe the stationary element sealing face
lightly in a concentric pattern with a clean, lint-free
cloth to remove any dirt or fingerprints.

Carefully slide the assembled intermediate and
stationary portion of the seal over the impeller shaft
(18) and secure the intermediate to the bearing
housing with the hardware (9, 10 and 11).

Slide the rotating portion of the seal assembly onto
the shaft until the seal faces contact.

Install the seal spring, spring seat and seal washer
(17).

Impeller Installation

Inspect the impeller, and replace it if cracked or
badly worn. Install the same thickness of impeller
shims (16) as previously removed. Apply ‘Loctite
Retaining Compound No. 242’ or equivalent com-
pound on the shaft threads, and screw the impeller
onto the shaft until tight.

A clearance of .008 to .015 inch ( 0,20 to 0,38mm)
between the impeller and the vane plate (24) is
necessary for maximum pump efficiency. Position
the vane plate over the impeller, and use a feeler
gauge to measure this clearance. Add or remove
impeller shims until the proper clearance is
achieved.

After the impeller clearance is set, secure the im-
peller to the shaft with the impeller nut (29).