Gorman-Rupp Pumps T2A60-B /F,/FM User Manual
Page 31
OM-05137
T SERIES
MAINTENANCE & REPAIR
PAGE E - 8
and work it up under the bellows. Slide the rotating
portion of the seal off the sleeve.
Use a pair of stiff wires with hooked ends to remove
the stationary element and seat.
An alternate method of removing the stationary
seal components is to remove the hardware (28
and 29) and separate the seal plate (5) and gasket
(6) from the bearing housing (8). Position the seal
plate on a flat surface with the impeller side down.
Use a wooden dowel or other suitable tool to press
on the back side of the stationary seat until the
seat, O‐rings, and stationary element can be re
moved.
Do not attempt to separate the rotating
portion of the seal from the shaft sleeve if
the old seal is to be reused. The rubber
bellows will adhere to the sleeve during
use, and attempting to separate them
could damage the bellows.
If no further disassembly is required, refer to Seal
Installation.
Shaft and Bearing Removal and Disassembly
(Figure 2)
When the pump is properly operated and main
tained, the bearing housing should not require dis
assembly. Disassemble the shaft and bearings
only when there is evidence of wear or damage.
Shaft and bearing disassembly in the field
is not recommended. These operations
should be performed only in a properly‐
equipped shop by qualified personnel.
Remove the bearing housing drain plug (22) and
drain the lubricant. Clean and reinstall the drain
plug.
Disengage the hardware (14 and 15) and slide the
bearing cap (26) and oil seal (24) off the shaft. Re
move the bearing cap gasket (13), and press the oil
seal from the bearing cap.
Place a block of wood against the impeller end of
the shaft and tap the shaft and assembled bear
ings (9 and 27) from the bearing housing.
After removing the shaft and bearings, clean and
inspect the bearings in place as follows.
To prevent damage during removal from
the shaft, it is recommended that bearings
be cleaned and inspected in place. It is
strongly recommended that the bearings
be replaced any time the shaft and bear
ings are removed.
Clean the bearing housing, shaft and all compo
nent parts (except the bearings) with a soft cloth
soaked in cleaning solvent. Inspect the parts for
wear or damage and replace as necessary.
Most cleaning solvents are toxic and
flammable. Use them only in a well‐ven
tilated area free from excessive heat,
sparks, and flame. Read and follow all
precautions printed on solvent contain
ers.
Clean the bearings thoroughly in fresh cleaning
solvent. Dry the bearings with filtered compressed
air and coat with light oil.
Bearings must be kept free of all dirt and
foreign material. Failure to do so will great
ly shorten bearing life. Do not spin dry
bearings. This may scratch the balls or
races and cause premature bearing fail
ure.
Rotate the bearings by hand to check for rough
ness or binding and inspect the bearing balls. If ro
tation is rough or the bearing balls are discolored,
replace the bearings.