beautypg.com

Gorman-Rupp Pumps T2A65-B /F,/FM User Manual

Page 34

background image

OM-05391

T SERIES

MAINTENANCE & REPAIR

PAGE E - 11

SEAL PLATE

O‐RINGS

IMPELLER

SHAFT

STATIONARY

SEAT

STATIONARY

ELEMENT

ROTATING

ELEMENT

DRIVE BAND

BELLOWS

IMPELLER

SHIMS

IMPELLER

SPRING

RETAINER

INTEGRAL

SEAL

SLEEVE

Figure 4. 46512-159 Seal Assembly

This seal is not designed for operation at
temperatures above 160

_

F (71

_

C). Do not

use at higher operating temperatures.

Lubricate the stationary seat O‐rings with water or
light oil, and install them in the stationary seat. In­
stall the stationary seal element in the stationary
seat. Press this stationary subassembly into the
front of the seal plate (5) until it seats squarely
against the bore shoulder. A push tube made from
a piece of plastic pipe would aid this installation.
The I.D. of the pipe should be slightly larger than
the O.D. of the shaft sleeve.

Install the seal plate gasket (6). Position the seal
plate over the shaft and secure it to the bearing
housing with the hardware (28 and 29). Be careful

not to damage the stationary element on the shaft
threads.

Lubricate the seal sleeve (4) with a small amount of
light oil and slide the rotating subassembly (con­
sisting of rotating element, bellows and retainer),
onto the sleeve until the rotating element is just
flush
with the undercut end of the sleeve.

Slide the sleeve and subassembled seal onto the
shaft until the seal faces contact. Continue to push
the sleeve through the seal until the undercut end
seats against the shaft shoulder.

Install the seal spring. Lubricate the seal as indi­
cated in LUBRICATION after the impeller is in­
stalled.

If necessary to reuse an old seal in an emer­
gency, carefully separate the rotating and station­
ary seal faces from the bellows retainer and sta­
tionary seat.