Pump and seal disassembly and reassembly – Gorman-Rupp Pumps T6A3-B /F,/FM User Manual
Page 29
OM-01046
T SERIES
MAINTENANCE & REPAIR
PAGE E - 6
PUMP AND SEAL DISASSEMBLY
AND REASSEMBLY
Review all SAFETY information in Section A.
Follow the instructions on all tags, label and decals
attached to the pump.
This pump requires little service due to its rugged,
minimum‐maintenance design. However, if it be
comes necessary to inspect or replace the wearing
parts, follow these instructions which are keyed to
the sectional views (see Figures 1 and 2) and the
accompanying parts lists.
As described on the following pages, this manual
will alert personnel to known procedures which re
quire special attention, to those which could dam
age equipment, and to those which could be dan
gerous to personnel. However, this manual cannot
possibly anticipate and provide detailed precau
tions for every situation that might occur during
maintenance of the unit. Therefore, it is the respon
sibility of the owner/maintenance personnel to en
sure that only safe, established maintenance pro
cedures are used, and that any procedures not ad
dressed in this manual are performed only after es
tablishing that neither personal safety nor pump in
tegrity are compromised by such practices.
Many service functions may be performed by
draining the pump and removing the back cover
assembly. If major repair is required, the piping
and/or power source must be disconnected. The
following instructions assume complete disassem
bly is required.
Before attempting to service the pump, disconnect
or lock out the power source and take precautions
to ensure that it will remain inoperative. Close all
valves in the suction and discharge lines.
For power source disassembly and repair, consult
the literature supplied with the power source, or
contact your local power source representative.
Before attempting to open or service the
pump:
1. Familiarize yourself with this man
ual.
2. Disconnect or lock out the power
source to ensure that the pump will
remain inoperative.
3. Allow the pump to completely cool
if overheated.
4. Check the temperature before
opening any covers, plates, or
plugs.
5. Close the suction and discharge
valves.
6. Vent the pump slowly and cau
tiously.
7. Drain the pump.
Use lifting and moving equipment in
good repair and with adequate capacity
to prevent injuries to personnel or dam
age to equipment.
Back Cover And Wear Plate Removal
(Figure 1)
The wear plate (12) is easily accessible and may be
serviced by removing the back cover assembly
(17). Before attempting to service the pump, re
move the pump casing drain plug (16) and drain
the pump. Clean and reinstall the drain plug.
Remove the back cover nuts (24) and pull the back
cover and assembled wear plate from the pump
casing (1). Inspect the wear plate, and replace it if
badly scored or worn. To remove the wear plate,
disengage the hardware (13 and 14).
Inspect the back cover O‐ring (15) and replace it if
damaged or worn.
Suction Check Valve Removal
(Figure 1)
If the check valve assembly (29) is to be serviced,
remove the check valve pin (31), reach through the
back cover opening and pull the complete assem
bly from the suction flange (30).
NOTE
Further disassembly of the check valve is not re
quired since it must be replaced as a complete unit.