NXG Technology NX-BAS-500 - Manual (Page 6)

6
1. IMPORTANT: Make sure that ALL system
components including the NX-BAS-500 are
turned OFF before proceeding.
2. Locate the LINE output RCA sockets on the
back of your preamplifier. These are typically
marked PRE, PRE OUT, LINE OUT or TO
POWER AMP, depending on the make and
model of component.
3. Connect a set of high-quality line level RCA
male to dual female Y-connectors to the pre-
amp’s LINE OUT sockets. Then connect a
pair of high-quality line level cables from the Y
connectors to the left and right LINE IN of
your subwoofer. Make sure that left is con-
nected to left and right is connected to right.
4. Connect another set of connection cables
between Y-connectors and the MAIN INPUTS
of your power amplifier. Again, make sure that
left is connected to left and right is connected to
right.
5. Connect your main speakers to the speaker
terminals on the back of your power amplifier.
6. You are now ready to put your NX-BAS-500
subwoofer into use. Skip to “E – INITIAL
LISTENING TEST.”
Method B: Line level hookup steps for systems with preamplifier and power amplifier
(Refer to Fig. 4 below)
FIG.4 –
Method B, Line Level
Hook-up with Preamplifier
and Power Amplifier
Y CONNECTORS