NXG Technology NX-MOUNT-ART-S User Manual
Page 2
P2
DISCLAIMER
– WARNING INFORMATION
TOOLS NEEDED
SYMBOLS
Drill
Level
Caution
Pencil Mark
Screwdriver
Tighten
Socket Wrench
Heavy!
3/16”
5/16”
4.8 mm
8 mm
Congratulations on the purchase of your new TV Mount. At NXG
Technology we design our products to be simple to use, durable, &
furnctional.
Like all NXG products, our mount line has evolved from hours of
rigorous testing by our engineers and customers and were
designed to provide you with years of enjoyment.
Please take a moment to review the installation instructions to
ensure that you get the most from your new mount.
Disclaimer
– NXG™ has extended every effort to ensure to accuracy and completeness of this manual. However, NXG does not claim that the information
covers all installation and or operational variables. The information contained in this document is subject to change without notice or obligation of any kind.
Regarding the information contained herein, NXG makes no representation of warranty, expressed or implied, and assumes no responsibility for accuracy,
sufficiency, or completeness of the information contained in this document.
WARNING: FAILURE TO READ, THOROUGHLY UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS CAN RESULT IN SERIOUS PERSONAL INJURY,
DAMAGE TO PERSONAL PROPERTY, OR VOIDING OF FACTORY WARRANTY!
It is the responsibility of the installer to ensure all components are properly assembled and installed using the instructions provided. If you do not understand these
instructions or have any questions or concerns, please send questions to [email protected].
Do not attempt to install or assemble this product if the product or hardware is damaged or missing. The included hardware is designed for use on vertical walls
constructed of wood studs or solid concrete. A wood stud wall is defined as consisting of a minimum of 2x4 wooden studs (2” wide by 4” deep) with a maximum of
5/8” drywall. The included hardware is not designed for use with metal studs or cinderblock walls. If you’re uncertain about the construction of your wall, then
please consult a qualified contractor or installer for assistance. For a safe installation, the wall you are mounting to must support 4 times the weight of the total load.
If not, then the surface must be reinforced to meet this standard. The installer is responsible for verifying that the wall structure and hardware used in any
installation method will safely support the total load.