NXG Technology NX-HDMIX-IR-100-1 - HDMI over single HDBaseT - Manual (Page 2)

TRANSMITTER (TX)
1. IR-TX port
2. HDMI input
3. Cat5e/6 output port
4. HDCP Status LED
5. Signal Connection Status LED
6. Status mode LED
7. Power LED
8. Power input
PANEL DESCRIPTIONS
SPECIFICATIONS
Operating Temperature Range -5 to +35° C (-41 to +95° F)
Operating Humidity Range 5 to 90%RH (No Condensation)
Input Video Signal 0.5-1.0 Volts P-P
Input DDC Signal 5 volts p-p (TTL)
Support Video Format DTV/HDTV:480i/576i/480P/576P/720P/1080i/1080P/4Kx2K
3D video
HDMI Output HDMI 1.4+HDCP
Support Audio Format DTS-HD Master Audio Dolby true-HD etc.
Transmission Distance 1080P 328FT/100m(Maximum) over single CAT5E/6 Solid
Power consumption 5 watts (Maximum)
Dimension (L x W x H) 87 x 70 x 24mm
Net Weight 260g (Pair)
Note: Specifications are subject to change without notice. Mass and dimensions are approximate.
2 3
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
POWER LED: indicates that power is connected to the unit.
MODE LED: When blinking, the LED indicates the device is active and working.
LINK LED: When the LED is ON, it indicates that an HD Base-T™ connection has been
established between the two units over the CAT5e/CAT6 cable.
HDCP LED: When the LED is ON, it indicates that video content with HDCP protection is
being transferred from unit to unit. When BLINKING, it indicates video content without
HDCP. When the LED is OFF, it indicates that no video signal is present or being transferred.
RECEIVER (RX)
1. IR-RX
2. HDMI output
3. Cat5e/6 input
4. HDCP Status LED
5. Signal Connection Status LED
6. Status Mode LED
7. Power LED
8. Power input
PRODUCT SERVICE
1) Damage requiring service: The unit should be serviced by qualified service personnel if:
(a) The DC power supply cord or AC adaptor has been damaged;
(b) Objects or liquids have gotten into the unit;
(c) The unit has been exposed to rain;
(d) The unit does not operate normally or exhibits a marked change in performance;
(e) The unit has been dropped or the cabinet damaged.
2) Servicing Personnel: Do not attempt to service the unit beyond that described in the
operating instructions. Refer all other servicing to authorized servicing personnel.
TYPICAL APPLICATION
CONNECTING AND OPERATING
1) Connect the HDMI signal source to HDMI Transmitter.
2) Connect CAT5e /CAT6 cables to both the CAT5e/6 of the transmitter and CAT5e/6 port of
the receiver. The RJ45 connections must follow EIA-TIA 568B standards.
3) Connect the HDMI output from the Receiver (RX) into the display HDMI input.
4) Connect the power supply into Power input jack.
5) Connect IR-TX cable into IR-TX port on the transmitter and affix the emitter onto the
source IR window.
6) Connect the IR-RX cable into the IR-RX port on the Receiver and affix the IR receiver
in direct line of site with the handheld remote control. It is recommended to affix the
receiver on the display frame / bezel or the display stand.
7) Gently Insert/Extract all cables.